32BIT – LET`S GET STARTED – Mr.Funk?
Updated on april 29, 2015 in Get started
5 on juli 25, 2014

Some words, some updates, some statements…

  • Liked by
Reply
0 on juli 26, 2014

At first it would be very helpful if the adminstrator would allow to upload pictures to the forum (currently disabled)…

  • Liked by
Reply
Cancel
0 on september 10, 2014

I can say that with the new firmware, the gimbal isn’t working properly at the moment..waiting for support, I will keep you updated

  • Liked by
Reply
Cancel
0 on april 27, 2015

update on 2.50b3 causes trouble. i cannot connect via bluetooth anymore

  • Liked by
Reply
Cancel
1 on april 27, 2015

Is the gimbal working?

on april 29, 2015

hey newton, thanks for answering.
Hey, after updating the firmware of the board from 2.42b7 to 2.50b3, i cannot establish any bluetooth connection to this lovely board. neither from pc nor from mac.
my pc can connect via bluetooth to the ”newton069″, but is not connecting with the software simplebgcGUI.
my mac is unable to connect. can you help us?
the gimbal is working properly, except that i have changed my profile 1, which is buggy due to several changes i made.
my question: how can i connect again. it is impossible to connect it via usb due to the fact, that the bluetooth board is soldered to mainboard, and i cannot reach the discribed ”flash”pins to update it via usb.

Show more replies
  • Liked by
Reply
Cancel